Rhino USA Recovery Tow Strap Review
3" × 20′ • 31,518 lb break strength • Static polyester webbing • Triple-reinforced loops • Lifetime replacement
What it is (and where it fits in your kit)
- Role: Static towing / controlled extraction strap. Think steady load transfer, not elastic yanks.
- Build: Dense polyester webbing for low stretch, abrasion resistance, and weather resilience.
- Ends: Triple-reinforced loop eyes (the highest-stress zone) for longer service life.
- Rating: 31,518 lb break strength (manufacturer). Use with rated gear and points.
Static strap vs kinetic rope
Static (this strap): minimal stretch (<≈5%). Best for towing on firm ground, straight pulls, repositioning a stuck vehicle, and controlled “assist” extractions.
Kinetic rope: high stretch (≈15–30%). Best for mud/sand where elastic energy helps “pop” a vehicle free. Requires tight comms and safe anchors.
When to grab which
- Use this Rhino strap for flat/firm recoveries, tow-outs to better terrain, or gentle tensioning.
- Use kinetic when wheels are buried and momentum + stretch are needed.
- Use a tree saver to anchor winching — don’t substitute a tow strap.
Rigging that keeps people safe
- Only attach to rated recovery points (no tow balls).
- Pair with rated shackles (soft or steel) sized for 3" webbing and expected load.
- Keep the strap straight; avoid sharp angles and side-loading the loops.
- Brief a spotter, clear the danger zone, and use steady throttle — avoid shock loads.
- After the pull: inspect webbing/loops for cuts, glazing, grit; rinse, dry, and stow flat.
Sizing & selection tips
- Width: 2" for small rigs/ATVs, 3" for midsize/full-size 4x4s (best all-rounder).
- Length: 20′ is versatile; 30′ gives easier positioning and gentler angles.
- Rating language: Know the difference between break strength and working load (rule-of-thumb WLL ≈ 1/3 MBS).
- Sleeves: Use abrasion sleeves at sharp/rough anchors.
Common mistakes to avoid
- Hooking to non-rated points (e.g., tow balls, thin tie-downs).
- Shock-loading a static strap like a kinetic rope.
- Cross-loading shackles; using pins that are too small for 3" webbing.
- Ignoring strap glazing/cuts; storing wet and sandy.
Key specs at a glance
| Product | Rhino USA Recovery Tow Strap |
| Size | 3" × 20′ (7.6 cm × 6.1 m) |
| Material | Polyester webbing (low-stretch / static) |
| Break strength | 31,518 lb (per manufacturer) |
| Ends | Triple-reinforced loop eyes, abrasion sleeves |
| Primary use | Controlled pulls, towing, gentle extractions |
| Warranty | Lifetime replacement (Rhino USA) |
Where this strap fits in our kit tiers
- Tier 1 — Essentials: Boards + static strap + shackles + shovel + PSI kit. Open Tier 1 guide
- Tier 2 — Core upgrades: Add kinetic rope, tree saver, radio comms. Open Tier 2
- Tier 3 — Expedition: Winch, upgraded points, sat comms, lighting. Open Tier 3
Related OGG reading
FAQ
Is this the same as a kinetic rope?
No. This is a static polyester strap for controlled pulls/towing. Kinetic ropes are nylon and designed to stretch for dynamic recoveries.
Can I use it for winching?
Use a tree saver to anchor winching. This strap is not a winch line.
What vehicle sizes does it suit?
Midsize to full-size 4×4 when used with rated hardware and safe technique. For very heavy trucks, step up ratings accordingly.
20′ or 30′?
20′ is compact and versatile. 30′ gives more line management and gentler angles; carry an extender if you often need distance.
Affiliate link — we may earn a small commission at no extra cost to you.
Bottom line
The Rhino USA 3" × 20′ tow strap is a no-nonsense staple for any recovery kit. Use it where static shines—towing, straight pulls, careful repositioning—and pair it with rated points, shackles, and good comms. It’s the quiet worker that makes messy situations boring (the goal).
